top of page
To test this feature, visit your live site.
Is it possible to flash to tasmota from homekit, without open case, via web interface?
Is it possible to flash to tasmota from homekit, without open case, via web interface?
2 answers1 reply
Like
Comments (3)
bottom of page
It can be done. When the switch is in AP mode you have to go to 192.168.4.1/update then you can upload your own bin file. On my 4 gang it just started clicking so you have to do the device recovery after that.
Procedure~
Cut power from the device completely for 30 seconds
Power the device on and off six times with intervals lower than 10 seconds and leave it on after seventh time
Fast power cycle device recovery should activate and the device should be reset to firmware defaults
Does not support upgrading from homekit to Tasmota